Форум » Вопрос профессионалу » Хамер H3

Отправлено: 13.03.08 23:39

вопрос можно ли поставить а.з.
если кто ставил то есть ли какие-нибудь тонкости

Отправлено: 14.03.08 23:54

HUMMER

MODEL YEAR(S)
H3 2006 -2007
KEY T-HARNESS IMMOBILIZER
N/A N/A Has NEW PASSLOCK II Anti-Theft System, Requires (2) Relays, a Resistor and a Diode , See DIAGRAM
PART COLOR LOCATION
12 VOLT CONSTANT Connect to Battery Only!
STARTER YELLOW/BLACK (-) Not Required for Remote Starting!! @ PCM, BLUE Plug, Pin 48, See NOTE *1
STARTER 2 N/A
IGNITION 1 WHITE/GREEN to DARK BLUE (+) @ IGNITION SWITCH HARNESS, or BCM, GRAY Plug, Pin B8, See NOTE *2
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 WHITE/RED to BROWN (+) @ IGNITION SWITCH HARNESS, or BCM, GRAY Plug, Pin B7, See NOTE *2
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) BROWN/WHITE (-) @ HEADLIGHT Switch or BCM, GRAY Plug, Pin A7, See NOTE *2
PARKING LIGHTS ( + ) BROWN (+) in DRIVERS KICK PANEL or BCM, BLACK Plug, Pin A48, See NOTE *2
POWER LOCK LIGHT BLUE (TYPE B) in EITHER KICK PANEL, @ DOOR HARNESS
POWER UNLOCK DARK BLUE (TYPE B) in EITHER KICK PANEL, @ DOOR HARNESS
DOOR TRIGGER See NOTE *3 @ BCM, BLACK Plug, See NOTE *2
DOMELIGHT SUPERVISION WHITE (-) @ BCM, BLACK Plug, Pin A46, See NOTE *2
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN GREEN to BLACK (-) @ HORN Switch or BCM, GRAY Plug, Pin A25, See NOTE *2
TACH Any wire NOT: PINK or BLACK @ Any IGNITION COIL or FUEL-INJECTOR
WAIT TO START LIGHT N/A
BRAKE LIGHT BLUE (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM N/A
ANTI-THEFT Has NEW PASSLOCK II Anti-Theft System, Requires (2) Relays, a Resistor and a Diode , See DIAGRAM See DIAGRAM
EXTRA INFORMATION
NOTE *1 The PCM is located on the PASSENGER side of the Firewall, under the Hood of the vehicle. NOTE *2 The BCM is located in the PASSENGER KICK PANEL. NOTE *3 the DRIVERS DOOR is a GRAY/BLACK (-) at Pin A32. The PASSENGER DOOR is a LIGHT GREEN/BLACK (-) at Pin A38. The DRIVERS REAR DOOR is a BLACK/WHITE (-) at Pin A39 and the PASSENGERS REAR DOOR is a LIGHT BLUE/BLACK (-) at Pin A44, all wires are located at the BCM, BLACK plug. When connecting to an ALARM SYSTEM use all 4 wires and DIODE ISOLATE, See DIAGRAM

Отправлено: 15.03.08 19:42

Огромное спасибо.
Откуда такая информация?

Отправлено: 16.03.08 1:00

большое спасибо так же, скоро наряжать такой танчик

Гость

На Автосете Кулибин выкладывал схемку, только зарегиться надо http://www.autoset.ru/forum/topic7270.html